Implementasi Algoritma 2 Step Kalman Filter Untuk Mengurangi Noise Pada Estimasi Data Accelerometer

Wahyu Sukestyastama Putra(1*),

(1) Universitas AMIKOM Yogyakarta
(*) Corresponding Author

Abstract


An accelerometer is a useful sensor in technological development. Currently, the accelerometer is found on smartphone devices, navigation devices, and wearable devices. However, processing the sensor output signal into data that can be interpreted is not easy. This is because the output of an accelerometer sensor has significant noise. In this study, the authors are interested in developing an estimation method using a Kalman Filter. Kalman filter is an estimator so it is expected that the sensor data are more resistant to noise interference. In this study, the author innovated the 2 step Kalman filter. The study was conducted because the use of 1 step still has noise on the estimation results. Based on the analysis of the algorithm simulation results, it can be concluded that the Kalman filter 2-step algorithm has good performance in estimating the accelerometer sensor output. When compared with the Kalman filter 1 step algorithm, the Kalman filter 2 step algorithm has a smaller average error estimation and is able to achieve a constant/stable condition faster than the Kalman filter 1 step method

Full Text:

PDF

References


N. M. Rizki and S. Handoko, “Aplikasi Musik Orkestra Angklung Multi Oktaf Berbasis Android Dengan Sensor Accelerometer,” Transformatika, vol. 15, no. 1, pp. 17–25, 2017.

T. Bombardini, R. Sicari, E. Bianchini, and E. Picano, “Abnormal shortened diastolic time length at increasing heart rates in patients with abnormal exercise-induced increase in pulmonary artery pressure,” Cardiovasc. Ultrasound, vol. 9, no. 1, p. 36, 2011.

W.-Y. Lin, K. V. Verma, M.-Y. Lee, and C.-S. Lai, “Activity Monitoring with a Wrist-Worn, Accelerometer-Based Device,” Micromachines, vol. 9, no. 9. 2018.

F. Bonin-Font, M. Massot-Campos, L. P. Negre-Carrasco, G. Oliver-Codina, and P. J. Beltran, “Inertial Sensor Self-Calibration in a Visually-Aided Navigation Approach for a Micro-AUV,” Sensors , vol. 15, no. 1. 2015.

C. S. Lee and K. S. Hong, “Velocity-Aided Attitude Estimation for Helicopter Aircraft Using Microelectromechanical System Inertial-Measurement Units,” Sensors , vol. 16, no. 12. 2016.

N. Hanafi, “Jurnal Rekayasa Elektrika,” J. Rekayasa Elektr., vol. 14, no. 36, pp. 205–213, 2018.

R. Maulana, W. Kurniawan, and H. Z. Fahmi, “Noise Reduction on the Tilt Sensor for the Humanoid Robot Balancing System Using Complementary Filter,” MATEC Web Conf., vol. 220, 2018.

Q. Cai, G. Yang, N. Song, and Y. Liu, “Systematic Calibration for Ultra-High Accuracy Inertial Measurement Units,” Sensors , vol. 16, no. 6. 2016.

M. Zhu, L. Pang, Z. Xiao, C. Shen, H. Cao, Y. Shi, and J. Liu, “Temperature Drift Compensation for High-G MEMS Accelerometer Based on RBF NN Improved Method,” Applied Sciences , vol. 9, no. 4. 2019.

P. Patonis, P. Patias, N. I. Tziavos, D. Rossikopoulos, and G. K. Margaritis, “A Fusion Method for Combining Low-Cost IMU/Magnetometer Outputs for Use in Applications on Mobile Devices,” Sensors , vol. 18, no. 8. 2018.

E. Edwan, S. Knedlik, and O. Loffeld, “Angular Motion Estimation Using Dynamic Models in a Gyro-Free Inertial Measurement Unit,” Sensors, vol. 12, no. 5. 2012.

G. Welch and G. Bishop, “An Introduction to the Kalman Filter.” Chapel Hill:University of North Carolina, pp. 1–16, 2006.




DOI: http://dx.doi.org/10.30645/j-sakti.v3i1.108

Refbacks

  • There are currently no refbacks.


J-SAKTI (Jurnal Sains Komputer & Informatika)
Published Papers Indexed/Abstracted By:

Jumlah Kunjungan :

View My Stats